See table to see how the Door Lock Mode parameter affects the lock. Notification Type Access Control, Event 0x04 (RF unlock operation) is sent to the Lifeline and then one second later, a Door Lock Operation Report is sent to the Lifeline. 2) To Unlock: Sending command class = COMMAND_CLASS_DOOR_LOCK, command = DOOR_LOCK_OPERATION_SET, mode = 0x00 (DOOR_UNSECURED) or BASIC_SET value 0x00 will unlock the door. Notification Type Access Control, Event 0x03 (RF lock operation) is sent to the Lifeline and then one second later, a Door Lock Operation Report is sent to the Lifeline. 1) To Lock : Sending command class = COMMAND_CLASS_DOOR_LOCK, command = DOOR_LOCK_OPERATION_SET, mode = 0xFF (DOOR_SECURED) or BASIC_SET value 0xFF will lock the door. When battery level is low a battery warning is sent to the controller.ĭoor Lock(V4) - Door Lock Operation is used to lock and unlock this product. ![]() The Lifeline group on this lock is used to report door lock operation report, and device reset locally notifications to nodes on the group list.īattery CC(V1) The Battery Get request can be used to get the status of the battery. Non-Secure added Support Support Support SupportĪssociation(V2) & Association Group Information(V1) - The product supports one association groups: -> Group 1 is the Lifeline group. Press the button after pressing the button.īattery Information 4 AA Alkaline 1.5V Batteries(6V) Press the Master Pin (Default value) button after pressing the button. Open the battery cover of the indoor body and press the button. Please use this procedure only when the primary controller is missing or otherwise inoperable. (You can check the DSK and QR code by removing the battery cover of the product or package box)įactory Reset Please proceed with the door lock open. No further action is required and the StartStart product will be added automatically within 10 minutes of being switched on in the network vicinity. SmartStart SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the product with a controller providing SmartStart inclusion. Press the button after pressing the button. ![]() To remove or exclude the GKBC-3100Z into a Z-Wave network 1. If the controller supports S2 security, you will be prompted to enter the first 5 digits of the DSK to complete the authentication, known as the Pin Code.(You can check the DSK and QR code by removing the battery cover of the product or package box) To add or include this product into a Z-Wave network 1. Standard Network Inclusion / Exclusion Please proceed with the door lock open. Z-Wave Specifications Device Type : Door Lock (SPECIFIC_TYPE_ DOOR_LOCK) Role Type : LSS (Listening Sleeping Slave) Command Cass Support/Control ![]() Inclusion can be via standard inclusion, SmartStart: The device can be included in the Z-Wave network using S0 or S2 Access Control security. ![]() All mains operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. This product is a secure electronic door lock that supports the Z-Wave PlusTM standard, which is compatible with earlier versions of Z-WaveTM.
0 Comments
Leave a Reply. |